Add: Room 804, 8F, Tian Fuxing building, Liu Xian road, Minzhi, longhua district, Shenzhen City, Guangdong Province
Feet Care Silicone Rubber For Insole Sole Heel
The shrinkage rate of Feet Care Silicone Rubber For Insole Sole Heel is good. Its shrinkage rate is in the thousandth. In addition, it also has good tensile strength, elasticity, and tear. This product has a large flow rate and good fluidity, which can work for a long time. It can produce elastic silicone molds with no deformation, high temperature resistance, acid and alkali resistance and no expansion.
The shrinkage rate of Feet Care Silicone Rubber For Insole Sole Heel is good. Its shrinkage rate is in the thousandth. In addition, it also has good tensile strength, elasticity, and tear. This product has a large flow rate and good fluidity, which can work for a long time. It can produce elastic silicone molds with no deformation, high temperature resistance, acid and alkali resistance and no expansion.
Physical properties of Feet Care Silicone Rubber For Insole Sole Heel
Item NO.:
RTV1510
Mix ratio:
1:1
Elongation:
>500%
Color:
Translucent
Tensile strength:
>3.5 MPa
Pot life time:
30-45 min
Hardness:
10±2 A
Shrinkage:
≤0.1 %
Cured time:
6-8 hours
Tear strength:
>16 N/mm
Viscosity:
3000±2000
Warranty:
12 month
Features:
1. It can be used for a long time in the temperature range of -65 ° C - 200 ° C and maintain its soft elastic properties.
2. This silica gel is environmentally friendly and non-toxic, and it is certified by SGS and ROSH.
3. It has excellent electrical properties and chemical stability, low line shrinkage, and it is resistant to water, ozone, weathering, non-corrosive, non-toxic and tasteless, easy to operate and so on.
Applications:
This feet care silicon rubber is suitable for shoe sole molding. It is widely used in hand molding, shoe molds, plaster models, sole sampling, sand casting, etc.
Detailed Images
Instructions:
Shoe mold silicone can be divided into two parts of A and B. Component A is a white flowing liquid and component B is a curing agent. For example: take 100 grams of silica gel and add 2% curing agent. Then mix the two components A and B evenly. After stirring evenly, the glue is placed in a vacuum box for defoaming, and vacuuming is performed. Finally, vacuum the vacuumed liquid silicone into the product or mold frame you want to copy.